Laptop screen going bad

LaptopScreen.com  /  Articles  / Quick fix tips for simple screen issues

Also see article What can be done if the new screen is not working?

Laptop screens are usually very reliable by themselves, and short of the known physical damage and cracks, here are some common ways to troubleshoot an LCD:

Is it the screen or is it the computer?

Unless the LCD is cracked, its best to first determine that the computer is working properly whenever graphical defects arise.

Graphics systems troubleshooting:

Whenever you see lines, artifacts, discolouration and oddities on your laptop screen it is very useful to connect an external monitor to your laptop to see if the image coming from the laptop is alright. If the same effect that was present on the internal LCD is displayed to the external monitor, then it becomes pretty obvious that the LCD itself is not the issue. Graphics Processing Units [GPU] and Video Memory are responsible for rendering the image from your computer onto any sort of display - internal and external. It is common for GPUs to fail due to over-heating. If you determine that the video defects are coming from your graphical system, unfortunately in most cases this would require a logic board replacement. Replacing an LCD will not fix the situation.

Video cable troubleshooting:

Electronics is all about good contacts. Time, air and moisture are the enemy of electronics because physical bumps or corrosion can disturb electrical contacts in connectors. If your image has disappeared, the screen is black or there are vertical and horizontal lines, your video cable may need to be reconnected. Typically image effects related to poor connections are intermittent. Lines would appear and disappear whenever the lid is opened or closed. Or sometimes the image is shaking but would become temporarily fixed with a slight bump. Or the colors are off/washed out and changing. You could disassemble your laptop and simply reconnect the LCD video connector a couple of times, doing so will scrape the pin contacts inside the connectors of any oxidation, and will fix any possibility that the connector simply became ajar over time. Replacing an LCD would fix such an issue - but thats only because you must disconnect the video connector to replace the LCD, the new LCD isn't necessary.

Software problem troubleshooting:

Sometimes things just go weird, and your computer may start locking up settings that were usually available. Things like resolution in the display options becomes locked to low resolution, or the refresh rate of the panel is locked to not allow the highest possible refresh rate [typically 60Hz], or the color definition output maybe diminished. Such effects are related to the graphical driver and may arise due to file corruption that forces your computer to load the safest defaults. Of course finding out that you can only use 800 x 600 or 1024 x 768 resolution versus your typical 1366 x 768 or 1920 x 1080 is inconvenient, but the problem is not due to the LCD itself. For a simple fix of such problems it is recommended to update/reinstall a video driver from your laptop manufacturer or your Gfx Chip manufacturer. One important thing to note about Graphics Drivers on Laptops vs Desktops. Whether you have an nVidia, AMD or an Intel graphical chip it is always better for desktop computer users to go straight to the respective Gfx chip manufacturer website and get the newest install package, as opposed to going to the computer or graphical card manufacturer's website. Well, it is the inverse for laptops. Due to the presence of additional custom hardware settings and devices, the laptop vendor sites will have a more appropriate graphics driver package than the gfx chip manufacturer. This isn't to say that the newest installer direct from nVidia/AMD will not work at all, but installing only the generic package may give rise to an issue with touchscreens and LCD color profiles that are custom to your specific laptop.

Is it the screen?

LCD screens rarely go bad on their own. In the past CCFL back-lit screens could burn out the back-light just like a regular light bulb could simply burn out. In some cases a failing CCFL bulb would color the LCD with reddish / pinkish tint. Since most laptops manufactured after 2012 come with LED back-lit screens, it is safe to assume that if your computer is not older than 5 years, it has an LED back-light. LED back-lights rarely go bad as their rated MTBF is usually 10 times longer than CCFL. So, what can fail in the LCD panel? Aside from the backlight, not a whole lot. The LCD itself is two panes of glass fused together with some really fine components sand-witched in between. Dead pixels, stuck pixels, bright pixels are the most common defects that are related to what goes on inside the LCD panel. One, two or three dead pixels are not an indication that the LCD is going bad, but if your screen suddenly develops several black dots, it is common for them to spread. This is related to the age of the LCD and can be fixed with a new panel. Some of the rarest cases of LCD failures are related to the LCD driver boards. LCD driver board is responsible for receiving the digital video signal from the graphical system and displaying it onto the individual physical pixels. Typical LCD driver failure would result in blank [transparent] image when the screen is turned on - power is supplied to the back-light but no pixels are being engaged by the driver board.

Cracked and water damaged screens

Physical damage is deadly to an LCD. A cracked LCD cannot be un-cracked or repaired, only replaced. Same goes for water damaged screens with internal staining.

© LaptopScreen.com, last updated June 14, 2018

When a laptop screen breaks, you’ll see various visual defects depending on precisely what broke. You may notice stuck, or incorrectly colored pixels, lines of color, bleeding colors, chunks of the screen appear black, or the screen may not turn on at all.

When a laptop screen is physically broken [such as a cracked screen], it’s usually due to physical damage. You may have dropped the laptop or dropped something on it. A laptop screen can even break if there is something as small as a bit of sand between it and the keyboard.

Some of the other issues that can cause a laptop screen to malfunction or seem broken include:

• Stuck pixels
• Screen burn
• Malfunctioning backlight
• Cable and connector problems
• Outdated driver

To fix your broken laptop screen, you’ll have to try each of these fixes. If the screen starts working, or you see enough improvement to begin using the laptop again, you can stop. If it stops working again in the future, return to the list and try the rest of the fixes.

If your screen is physically cracked and the underlying panel is damaged, these fixes won't work. To fix a physically cracked or broken screen, the only option is to replace the screen.

1. Restart your laptop. The screen not appearing to work may be caused by an operating system issue, or some other conflict will be cleared by simply restarting the computer. Since restarting is so easy, it should be the first thing you try.

2. Close the laptop and reopen it. Examine your keyboard and screen areas for any debris, and clean them thoroughly. If your laptop uses a visible latch, clean the latch mechanism. Carefully close the laptop, ensure it is completely closed, and open it back up. If the screen sometimes turns on and sometimes doesn’t, you probably have a bad lid sensor.

3. Plug in an external monitor. If your screen is entirely black, try plugging in an external monitor. If the external monitor doesn’t work, your laptop may not be on, or it may be asleep or in hibernation mode. Plug it in, and make sure it's on.

4. Update your video drivers. If your screen isn’t completely black, but you see visual defects on the screen, try updating your video drivers. You may have a malfunctioning or glitchy driver.

5. Try to unstick your stuck pixels. If you’re dealing with one or more stuck pixels, you can use an app to try and unstick them. These apps typically cycle between colors rapidly or generate digital snow to force a dead or stuck pixel to start working again.

6. Try to fix your burn-in. If it looks more like you have ghosts of old images stuck on your screen, then you can try a white screen saver or a few other potential fixes to remove the burn-in.

7. Check your screen and backlight connections. If you have experience with disassembling laptops, you can remove the bezel around your screen, hinge covers, or other case components to reveal the screen and backlight wires and connectors. Make sure everything is fully seated and the cables aren’t crimped or broken.

8. Replace the screen. If nothing else works, then your screen probably has to be replaced. Screens with large black or colored bars, black holes, or colors that seem to run are typically beyond repair. If it's a cracked screen, that’s also a clue you’ll have to replace it.

FAQ

• What can I do with a broken laptop?

  Make use of your broken laptop by salvaging the hard drive as an external hard drive and selling any other parts that still work. If the display still works, use it as a standalone monitor. If you decide to sell your laptop, perform a factory reset to wipe your personal files.

• How much does it cost to replace a broken laptop screen?

  Getting your screen professionally repaired will likely cost $200 or more. You may be able to find a screen and replace it yourself for less than $100. Before you spend money on repairs, consider upgrading to a new laptop.

• How do I fix my laptop not turning on?

  Check and replace the power supply if necessary. Detach any bootable media drives, docking stations, and newly installed components that could be interfering with startup. You may need to clear the motherboard CMOS by reseating the CMOS battery.

Thanks for letting us know!

Tell us why!