Lỗi ghost has detected corruption in the image file năm 2024
It was installed IDS V108 on Vmware to work with my Ford VCM II. When I run the software, I get the application error 27076 message “Ghost has detected corruption in the image file. Please perform an integrity check on the image…” is shown as below. It was installed IDS V108 on Vmware to work with my Ford VCM II. When I run the software, I get the application error 27076 message “Ghost has detected corruption in the image file. Please perform an integrity check on the image…” is shown as below. The possible cause: Maybe there is something wrong with the file.The solution: Uninstall the current software and install by the following download link. https://share.weiyun.com/5S508ie Password: ynd37s Security: Yes, it has been tested 100% ok by obdiitool.co.uk engineer. Operating system: You’d better install Ford IDS V108 on Win7 Recommend WIN7 32bit system download link:https://share.weiyun.com/59Noy7p Password: 0awk7b Computer operating system requirements: 1.If your computer hard drive only has one partition, please prepare a 16GB U flash drive 2.If has 2 partitions, please unzip the software into any other partition except disk C. Note: If you don’t know how to download software from WeiYun, please refer to this article: https://www.obdiitool.co.uk/info/how-to-download-software-from-weiyun.html Guide to install Ford IDS V108 software for VCM2: Extract Ford 108 software, delete the redundant files Click on GHOST 8.0 to one key recovery Restart computer Click on Ford extending programming Find VCI Manager (Ford-VCM-II) to installIf it prompts “PC software initialization error (getmoduletype), please go to Computer-> program files-> Ford motor company-> IDS-> Runtime-> install3rdparty-> ETAS-> setup Install Bosch VCI ManagerWhen install successfully, run VCI Manager (Ford-VCM-II) Connect VCMII to computer as below Go to computer management-> Device manager->Network adapters to check whether the device connect successfully Make sure the Internet connection is normal Then you can run IDS 108 softwareHello, I backed up my system using Norton Ghost 3.0 and had an MP3 file on the hard disk that was corrupt. Now I can not uncompress or read my ghost images. I always get a CRC error. Here's the most pertinent information I've found so far, http://service1.symantec.com/SUPPORT/ghost.nsf/docid/2000051614544325 I've tried everything on this page and have had no luck. What I want: To pay someone to retrieve some data from these image files, not all the data, just some of it (images mostly JPG and PSDs). Or for someone with hex editing experience to tell me if its even possible. What I have: 9 Ghost image files on DVD+RW, each 1 GB except for the corrupt file ( 5) and the final file (9). The MP3 file that is causing the problem is not one I'm trying to restore.A successful restoration of my JPG and PSD image files will win you $150. |